12
POINT I/O Dual Port EtherNet/IP Adapter
Publication 1734-IN041F-EN-P - May 2019
Replace the Adapter
Use these procedures to install a replacement adapter to an existing system.
1.
Disconnect the Ethernet connector(s) from the adapter.
2.
Pull up on the Removable Terminal Block (RTB) handle to remove the terminal
block.
3.
Remove the adjacent module from its base.
4.
Use a small bladed screwdriver to rotate the DIN rail locking screw to a vertical
position. This releases the locking mechanism.
5.
Lift straight up to remove.
WARNING:
If you connect or disconnect the communications cable with power
applied to this module or any device on the network, an electrical arc can occur.
This could cause an explosion in hazardous location installations.
Be sure that power is removed or the area is nonhazardous before proceeding.
WARNING:
When you connect or disconnect the Removable Terminal Block
(RTB) with field side power applied, an electrical arc can occur. This could cause
an explosion in hazardous location installations.
Be sure that power is removed or the area is nonhazardous before proceeding.
WARNING:
When you insert or remove the module while backplane power is
on, an electrical arc can occur. This could cause an explosion in hazardous
location installations.
Be sure that power is removed or the area is nonhazardous before proceeding.
Repeated electrical arcing causes excessive wear to contacts on both the
module and its mating connector. Worn contacts may create electrical
resistance that can affect module operation.
ATTENTION:
Do not remove or replace an Adapter Module while power is
applied. Interruption of the backplane can result in unintentional operation or
machine motion.
