WZ
3
12MON
SYS-LINK Option Fitting Instructions AP7007
3
Step 5:
Fit the SYS-LINK cards to
the console
Each SYS-LINK circuit card assembly is fixed to
the connector panel using two M4 D-type
connector nuts. These are supplied already
fitted to the card’s sockets. Remove the nuts
and place the card into the connector panel
slots, observing the correct slot position and
orientation. Secure the SYS-LINK card by
refitting the D-type nuts, ensuring that they are
fully tightened.
Check that the SYS-LINK IN card is fitted to the
top slot, and SYS-LINK OUT card fitted to the
lower slot.
Step 6:
Connect the OUT card
Plug one end of the supplied short IDC harness
AL6098 into header CN1 on the SYS-LINK OUT
card. Plug the other end into the corresponding
IDC header CN236 on the connector card.
Step 7:
Remove the clamp bracket
and blanking plate
Remove the five M3 nuts that fix the clamp
bracket to the connector pod chassis. Remove
the clamp bracket. Remove the two M3 blanking
plate screws from the User Option Port A on rear
of the connector pod. Remove the blanking
plate.
Step 8:
Connect the IN card
Take the harness of Mix 1, 2, 3 and 4 and plug
one of the connectors into the slave PCB then
plug the slave PCB back on to Mix 1, 2, 3 and 4.
Plug long harness AL7005 into CN6 on the slave
card.
Run the harness back through the console,
passing the unconnected end through the first
opening of the chassis connector.
RUN IDC HARNESSES
THROUGH THIS OPENING
Run the harness along and over the connector
card as shown below.
Plug harness AL7005 into the connector on the
SYS-LINK Input card (marked CN1 – SYS IN).
SLAVE
AL7005
REMOVE 5x M3 NUTS AND BRACKET
IN
OUT
