2
WZ
3
1442
SYS-LINK Option Fitting Instructions AP5737
Important Information
NOTE:
Any changes or modifications to the
equipment not approved by Allen & Heath could
void the compliance of the equipment. Whilst
we believe the information in these instructions
to be reliable we do not assume responsibility
for inaccuracies. We also reserve the right to
make changes in the interest of further product
development.
Copyright© 2004 Allen & Heath Limited. All
rights reserved.
www.allen-heath.com
IMPORTANT :
This work should be carried out by
competent technical personnel only.
Disconnect the mains power cord
before opening the unit.
Take care not to damage the panels or
internal assemblies during fitting. Prevent
loose parts or dirt from entering the console
as this may cause equipment failure if not
removed.
Fitting Instructions
Step 1:
Preparation
Ensure the console is powered off.
Disconnect the mains power lead and all
connected cables.
Ensure the work surface is approximately twice
the depth of the unit.
Remove the console from its rack or other
furniture and place on the work surface.
Step 2:
Remove the base
Start by removing the side trims if fitted: four
M4x10 Pozi screws per side.
Turn the console upside down.
Release the two M4x8 flange Pozi head pod
securing screws and rotate the connector pod to
gain access to the three M3x6 Torx rear base
fixing screws.
Remove these screws and rotate the pod again
to remove the four M3x6 Torx underside base
screws.
Carefully lift off the base.
REMOVE SIDE TRIMS
REMOVE M4 POZI SCREW PER SIDE
ROTATE POD
REMOVE 4x M3 TORX SCREWS
REMOVE 4x M4 POZI SCREWS PER SIDE
REMOVE 3x M3 TORX SCREWS
ROTATE POD
