4
1
2
5
4
3
X
X
*
*
1011mm
To finished
floor
For double doors with a
mullion and strike already
installed, use existing
strike center line.
Notes:
For 499F strike installation, see page 8.
For double door application in combination with a 98/9927
device, see “Preparation for 1609 Strike” on page 7.
A
See “Screw Chart” on page 2
for screw types and sizes
6
RHR Shown
(LHR opposite)
CL
Draw Horizontal Device and Strike Center Line ( )
Align Strike on and Mark the Two Slotted Holes
Prepare 2 Holes and Install 2 Screws
Position Template Against Strike and on then
Mark Door
If Using an Outside Cylinder, Check NL Drive Screw
299/299F Strike
Installation Shown
Roller
#25 Drill
#10-24 Tap
#3 mm Drill
Pilot 25 mm
Deep
Meta
l
Woo
d
C
L
C
L
Template
(align on and
against strike)
Mark
vertical
Mark 6
holes
Prepare Door for Device and Trim
See trim instructions for pull side door
preparation. Line
X-X
in trim instructions
is same as vertical device
C
.
L
See “Preparation Chart” on
page 6 for drill, tap,
and cut-out information
When installing trim that has a functional lever,
knob, or thumb piece AND an outside cylinder to
lock and unlock the trim, remove NL drive screw
from back of device.
DO NOT remove NL drive screw for the following
application:
NL, EO, DT, TP-2, L-2, and K-2
trims or with 98/99-2 (double cylinder).
With “
BE
” trim, device may need to be rehanded.
See instructions on back of trim.
NL drive screw
Note: When the NL drive
screw is left in back of
device, the outside cylinder
will function only as a Night
Latch.
Summary of Contents for Von Duprin 98/99
Page 12: ...12 ...
