Allegion Schlage L-Series, Service Manual

Page: 227 / 232

L400-Series 180 degree indicator installation instructions
Schlage • L-Series service manual • 227
© Allegion 2015
P516-911 Rev. 03/15-b
INDICATOR LOCK RETROFIT INSTRUCTIONS
1
Remove armor front
2
Remove cylinder(s) or thumb turn if applicable
2a Loosen the cylinder mounting screw.
2b Remove the outside cylinder, if applicable.
Insert the key halfway into the cylinder and rotate
cylinder counterclockwise to remove.
Key inserted
halfway
2c Repeat for the inside cylinder, if applicable.
2d Remove inside turn, if applicable.
Rotate 180 °
Extend
deadbolt
3
Check door preparation
IMPORTANT
• To install the indicator trim, additional door preparation
may be required. If additional door preparation is required,
remove the lock chassis from the door before drilling. Steps
for reassembly are included in this instruction sheet.
• Please refer to the template included in this package.
• Make sure the door is prepared with any necessary holes for
the indicator trim.
4
Complete installation of indicator trim
Go to STEP 4 ON PAGE 2 and follow the instructions to
complete the installation of the indicator trim.
Customer Service
1-877-671-7011 www.allegion.com/us