1
Page 2 of 8
75.0022.01 ALLEGION 8310-816 TOUCHLESS ACTUATORS 20200612
AP
PLI
C
A
TI
O
N
S
TI
PS
1. Install the electrical box.
2. Remove the two (2) set screws.
3. Disassemble (i.e. slide up and pull out) the faceplate assembly from the mounting ring.
4. Temporarily mount the mounting ring to the electrical box. Pay attention to “THIS END UP”.
5. Mark four (4) hole locations for installing the mounting ring.
6. Remove the mounting ring from the electrical box.
7. Install four (4) wall anchors.
8. Mount (i.e. hand-tighten) the mounting ring to both the electrical box and the wall.
9. Remove the back of the NEMA 4 enclosure.
10. Sections 2 (WIRING) and 3 (SETTINGS & ADJUSTMENTS) must be completed prior to continuing
installation (Section 4).
Single Swing Doors
Dual Egress Swing Doors
Sim Pair Swing Doors
Sliding Doors
INSTALLATION
Only trained and qualified
personnel are recommended to
install and set up the sensor.
The warranty is invalid if
unauthorized repairs are made
or attempted by unauthorized
personnel.
Always test the proper
operation of the installation
before leaving the premises.
PRECAUTIONS
NOTE:
Do not install the sensor within the swing path of the door.
• Single gang or double gang electrical boxes (ideally, non-metallic) may be used.
• Single gang electrical boxes are recommended for 4.75” square version.
• Set screws are 4/40 × 1/2” Allen head screws, adjusted with 3/32 Allen wrench (supplied).
• Mounting screws are #6-32 × 1/2” Phillips head screws.