Allegion 8310-880, Instructions Manual, Page: 7 / 8

75.0023.01 ALLEGION 8310-880 900 MHZ TRANSMITTERS_RECEIVERS 20200612 Page 7 of 8 75.0023.01 ALLEGION 8310-880 900 MHZ TRANSMITTERS_RECEIVERS 20200612 Page 7 of 8
Frequency: 908 – 918 MHz
Radio Control Type: Digital
Emitted Radio Power: -25 dBm (TX)
Power Consumption: STANDARD:
30mA (TX)
40mA (RX)
RETROFIT:
22 mA
UNIVERSAL:
30mA
Input Voltage: 12 – 24 VAC / VDC
Contact Rating: 1.0 A @ 30 VDC
0.3 A @ 60 VDC
0.5 A @ 125 VAC
Operating Temperature: 14 – 131
°
F (-10 – 55
°
C)
Transmitter capacity (per receiver):
Programmable (standard):
Universal:
75
unlimited
LEDs: Receivers:
Red (Receiver Learn)*
Blue (Relay Activation)
Tri-color (signal strengths)
Transmitters:
Red = Transmitting
Red blinking = low battery
Dimensions:
Transmitter:
Receiver:
Standard Hand-Held: 2.75” (W) x 1.38” (D) x 0.56” (H)
Standard Push-Plate Transmitter: 1.75” (W) x 1.0” (D) x 0.3” (H)
Retrofit: 1.72” (W) x 1.06” (D) x 0.32” (H)
RD900: 2.5” (W) x 2.0” (D) x 0.75” (H)
Norm Conformance: All: FCC, IC
TECHNICAL SPECIFICATIONS
Specifications are subject to change without prior notice.
All values measured in specific conditions.
TROUBLESHOOTING
Weak signal Receiver antenna wire
poorly positioned Position antenna outside of door header.
STD TRANSMITTERS
ONLY:
Red LED on receiver is
flickering; unable to
program
Stuck push plate or faulty
transmitter Disconnect each push plate until LED goes
out.
Faulty transmitter Remove each transmitter battery until LED
goes out. Replace faulty transmitter.
RETROFIT
TRANSMITTERS ONLY:
No activation
Power wires not connected Verify power connect at transmitter,
touchless plate, and power source.
Activation wires not
connected Verify activation connection at transmitter
and door control.
Receiver not programmed Set up transmitter.
RETROFIT
TRANSMITTERS ONLY:
Constant activation
Something is moving in
front of the touchless plate Clear the area around the plate.
Transmitter connected to
NC of touchless sensor Connect to NO.
Receiver and/or touchless
sensor set to Toggle Mode Set receiver and/or touchless sensor to
Pulse Mode.