75.0023.01 ALLEGION 8310-880 900 MHZ TRANSMITTERS_RECEIVERS 20200612
Page 3 of 8
75.0023.01 ALLEGION 8310-880 900 MHZ TRANSMITTERS_RECEIVERS 20200612
Page 3 of 8
WIRING
POWER
RELAY CONTACTS
LABEL
12 – 24
12 – 24
COM
NO
NC
WIRE COLOR
Red (+)
Black (-)
white
green
yellow
TERMINAL
1
2
3
4
5
DESCRIPTION
Control or Transformer power
Control Common
Control Activation
Typically not used
TOUCHLESS RETROFIT TRANSMITTER
RECEIVER
In most applications for existing hard-wired touch push plates, only two (2) wires are installed which
run within the wall from the push plate to the door control for activation.
The 900 MHz Touchless Retrofit Transmitter allows an existing, hard-wired, touch, push plate to be
retrofitted with a new touchless plate that requires four (4) wires (2 wires for power and 2 wires for
activation) without running additional wires.
This is achieved by use of a powered wireless transmitter and wireless receiver.
1. Remove existing touch push plate and disconnect the two (2) existing in-wall wires from the
push plate and door control activation.
2. Connect the green and white wires to the new touchless plate activation output (see image,
right).
3. Parallel the red and black wires with the two (2) existing in-wall wires and connect them to the
new touchless plate power input (see image below).
4. Mount new touchless plate.
5. Connect the two (2) existing in-wall wires to the power source in the door control header.
6. Install the 900 MHz wireless receiver in the header (sold separately).
ACT
COM NO
PWR
+ -
Touchless
Retrofit Transmitter
TOUCHLESS PLATE