ALLDSP ASP-2M6
3.3. Output Setup
Select the output channel you wish to edit by pressing the channel button below the VU meter for the
corresponding channel once. Make the first settings with the output turned low or muted.
To toggle through the different items, press the Item Up or Item Down buttons.
3.3.1. Gain
Adjust the gain by dialing the rotary encoder. The gain is adjusted in steps of 0.25dB. Smaller steps (0.01dB)
can be set via the PC or MAC interface.
3.3.2. Mixer
Turn the rotary encoder to mix the signal from the selected input to the selected output. Push the rotary
encoder to select the input. Attention: The mixer is only available while the outputs are not linked by Channel
Link. If the channels are linked, the mixer will be skipped.
3.3.3. Delay
Set the delay time by turning the encoder. Select the displayed unit (ms or s, mm or m, feet, inches, or mils)
by pushing the encoder.
3.3.4. Low Pass Filter
Adjust the Low Pass Filter frequency by turning the rotary encoder. You can switch the low pass filter off by
turning the rotary encoder up (clockwise) until the frequency passes 20kHz.
Press the rotary encoder to change the filter type. Select the type by turning the rotary encoder. You can
choose from: Butterworth 6dB, Bessel 6dB, Butterworth 12dB, Bessel 12dB, Linkwitz Riley12dB, Butterworth
18dB, Bessel 18dB, Butterworth 24dB and Bessel 24dB. Higher order filters may be set by adding filter
sections in the PEQ blocks (see below).
3.3.5. High Pass Filter
Adjust the high pass frequency by dialing the rotary encoder. You can switch the high pass filter off by dialing
the rotary encoder down (counterclockwise) until the frequency passes 20Hz.
Press the rotary encoder to change the filter type. Select the type by turning the rotary encoder. You can
choose from: Butterworth 6dB, Bessel 6dB, Butterworth 12dB, Bessel 12dB, Linkwitz Riley12dB, Butterworth
18dB, Bessel 18dB, Butterworth 24dB and Bessel 24dB. Higher order filters may be set by adding filter
sections in the PEQ blocks (see below).
Page 10/13
