First of all,
Once you have determined the correct diameter,
please see the relative diagram as below. You will thread the Bolt into the TV using the correct Lock Washer(q,r,s,t),
Washer(w,x) and spacer(u,v). For the M5 diameter bolt, you will need another M5 Washer between the Monitor Bracket
and the Spacer. Please make sure the Monitor Brackets are vertically centered and level with each other.
make sure the diameter of the Bolt(m,n,o,p) your TV requires.
Step 2B
Mounting the Wall Plate to the Wall
Step 3
Brick, Solid Concrete and Concrete Block mounting:
Use the each of Wall Plate(a) as a template to mark 4 hole locations on the wall. Two in the top row of slots and two more in
the bottom row. Make sure these holes are level and there is at least 6"(150mm) distance between any two holes. Pre-Drill
these holes with a 3/8"(10mm) masonry bit to at least 2.4"(60mm) in depth. Insert a Concrete Anchor(A) into each of these
holes. Make sure the anchor is seated completely flush with the concrete surface even if there is a layer of drywall or other
material in front. Attach the Wall Plate to the wall using 4pcs Lag Bolts(y) and 4pcs Lag Bolt Washers(z), shown in Diagram
3B.
Wood Stud mounting:
Each of Wall Plate(a)
must be mounted to two wood studs at least 16"(406mm) apart.
Use a stud finder to locate two
adjacent studs. It is a good idea to verify where the studs are located with an awl or thin nail. Pre-drill a 2.4"(60mm) deep
hole at the desired height in each stud using a 5/32"(4mm) drill bit. Make sure these holes are in the center area of the
studs and level with each other. Use the Wall Plate as a template to mark the location of the second hole in each stud. Drill
2.4"(60mm) deep holes using the 5/32"(4mm) drill bit in the marked locations. Attach the Wall Plate to the wall using the
4pcs Lag Bolts(y) and 4pcs Lag Bolt Washers(z).
Diagram 3B
Diagram 3A
Mounting the Monitor Brackets to a TV with Curved Back
4
M5 Diameter Bolt
M8 Diameter Bolt
M6 Diameter Bolt
M10 Diameter Bolt
Diagram 2B
m
n
o
p
q
r
s
t
w
x
x
x
w
u
u
v
v
b
b
c
c
B
C
a
y
z
A
Determine the proper width you want for wall plate, than insert the Connection Bar(B) into the slot in the middle of each
Wall Plate. Insert the Bolt(C) into the threaded holes in the connection bar shown in Diagram 3A.
