7
Measuring Battery Voltage
value of the resistor under test can affect the
measurement result.
2. The frequency of the meter's test signal is 1kHz.
3. When the test probes are in open circuit state, the
display will show " 1 " as an overrange indication.
4. Before measurement, disconnect all power to the circuit
to be tested and discharge all capacitors thoroughly.
5. For measurements in the 200m range, set the range
switch in the 200m range position and short the two
test probes, the display will show a reading. This
reading must be subtracted from all the measurements
in the 200m range.
