21
Owner’s Manual
Compressor (cont’d)
BREAKING IN THE PUMP
BEFORE STARTING MAKE SURE COMPRESSOR HAS OIL (see page 23)
1.Turn the switch to the OFF position.
2. Open the petcock. Turn counterclockwise (loosen).
3. Plug in the power, switch to the ON position.
4. The compressor will start.
ALLOW THE COMPRESSOR TO RUN FOR 15 MINUTES, TO BREAK IN THE
INTERNAL PARTS.
CAUTION:
AFTER ABOUT 15 MINUTES. IF THE UNIT DOES NOT
OPERATE PROPERLY.SHUT DOWN IMMEDIATELY, AND CONTACT PRODUCT
SERVICE CENTER.
5. After about 15 minutes, turn the power switch to the OFF position.
6. Close the petcock. Turn in the clockwise direction.
7. Turn the power switch to the ON position. The compressor will start and fill the tank
to the kick-out pressure and stop.
Note:
As compressed air is used, the pressure switch will restart the
motor automatically.
Note:
During the initial break-in cycle, there will be a slight electrical
smell as the motor brushes seat .This is normal for universal motors and will last for
about 5 minutes.
OPERATING INSTRUCTIONS
Daily Startup
1. Turn the power switch to the OFF position.
2. Close the tank petcock. Turn in the clockwise direction.
3. Plug in the power cord.
4. Turn the power switch to the ON position
22
Owner’s Manual
Compressor (cont’d)
OPERATING INSTRUCTIONS
WARNING!
HIGH TEMPERATURES ARE GENERATED BY THE
ELECTRICAL MOTOR AND THE PUMP. TO PREVENT BURNS OR OTHER
INJURIES, DO NOT TOUCH THE COMPRESSOR WHILE IT IS RUNNING. ALLOW
IT TO COOL BEFORE HANDLING OR SERVICING. KEEP CHILDREN AWAY FROM
THE COMPRESSOR AT ALL TIMES.
WARNING!
WHEN ADJUSTING FROM A HIGHER TO A LOWER
PRESSURE, TURN THE KNOB COUNTERCLOCKWISE TO REACH THE DESIRED
PRESSURE. DO NOT EXCEED OPERATING PRESSURE OF THE TOOL OR
ACCESSORY BEING USED.
5. Adjust the regulator to the working pressure of the tool. (never exceed 90 PSI)
Shut down
1. Turn the power switch to the OFF position.
2. Unplug the power cord.
3. Reduce pressure in the tank through the outlet hose .You can also pull the relief
valve ring and keep it open in the tank.
WARNING!
ESCAPING AIR AND MOISTURE CAN PROPEL DEBRIS
THAT MAY CAUSE EYE INJURY. WEAR SAFETY GOGGLES WHEN OPENING
PETCOCK
4. Tip the compressor (if necessary for your model ) so the petcock is at the bottom of
the tank(S).Then open the petcock to allow moisture to drain from the tank.