All Pond Solutions ACP-1000, Instruction Manual

Page: 2 / 15

To ensure your new submersible pump is set up and running correctly, and to
prevent any accidental damage or injury, please read and follow the below
instructions carefully before using your product.
SAFETY
Important! Disconnect the mains electricity supply before attempting any
installation / maintenance of any kind. Do not attempt to modify this unit in
any way and only use the recommended parts for replacement.
·
The pump should never be run dry as this will cause the unit to overheat
and cause permanent damage.
·
All connections must be earthed.
·
The power cord of this appliance cannot be replaced; if the cord is
damaged, the appliance should be discarded. Never cut the cord.
·
Do not connect to any voltage other than that stated.
·
This pump is suitable for indoor household aquariums only (do not use in
exterior locations, swimming pools, ponds, bathrooms etc). Do not place in
liquids other than water.
·
Do not use with water above 90F or 30C.
·
Do not carry or pull the unit by its electrical cable.
·
Do not use this unit if it has a damaged cord or plug, if it is malfunctioning
or it is dropped or damaged in any manner
·
Do not yank cord to pull plug from outlet. Grasp the plug and pull to
disconnect. Always unplug an appliance from an outlet when not in use.
·
Do not attempt to modify this unit in any way and only use the
recommended parts for replacement.
·
Before installing, maintaining or handling your equipment, or before placing
your hands in your aquarium, ensure that the unit is disconnected from the
electricity supply.
·
Always unplug any electrical devices when not in use.