sensors
discharge pump
incoming water line
regulator
Oatmeal Shampoo
Tearless Shampoo
Conditioner
Flea & Tick Treatment
Pet Deodorizer
Tub Disinfectant
• Every ADA Modular Building comes with a trough which runs
through the equipment room. The floor in the building is
sloped toward the equipment room allowing gravity to carry
excess water under the wall and into the trough. Once the
sensors detect that theres a collection of water in the trough,
the discharge pump will kick on, draining the trough.
•
In this example, the blue pipe is the
incoming water line. It runs through the
pressure regulator which adjusts the
overall pressure of the incoming water.
Pressure can be adjusted by turning
the bolt on top of the regulator. After
passing through the regulator, water
passes on to the water filter and then
through the water heater. After being
heated, the water then runs to the
water column.
• Insert suction strainers leading from selenoid valves into appropriate soap and
treatment containers.
2. Plumbing
I. OVERVIEW (cont.)
4
9
The following are general, suggested guidelines for daily, weekly, monthly, and bimonthly
maintenance on your All Paws Pet Wash self serve pet wash vending station. You may find
more applicable methods of maintenance in the daily operation of your personal unit.
DAILY MAINTENANCE
WASH AREA
• Rinse wash tub
- Open equipment room door, reel out 20ft hose to swing/sliding door of
wash bay. Spray down wash bay walls, floor and tub towards equipment room wall.
• Clean glass if needed - Spray glass with Glass Stripper starting from the top and work your
way to the bottom.
• Skim trough for solid debris - Using a small hair strainer, skim the trough to collect larger
pieces of debris, hair and other particles to avoid clogged floor pumps.
EQUIPMENT AREA
• Rinse Vacuum -
Open equipment room door, walk in and turn water valve counter-clockwise
to allow water to be flushed through vacuum for a duration of five seconds. Turn valve clock
wise to OFF.
• Dump hair strainer
- Open equipment room door, walk in towards back corner and grab
strainer by brown handle. Dump into an external trash receptacle.
• Check soap levels -
Open equipment room door, walk in and locate soaps. Use the guide
illustrated on this page to determine necessary fill-ups. Remember to use the ratio of 20:1
water to concentrate. Refer to the label on your 2.5 gallon jug for more information.
*Depending on water hardness, water to soap ratios may need adjusting.
WEEKLY MAINTENANCE
•
Check filter on blow dryer, clean as needed
- Filter is located on the back side of dryer. You
will need a philips head screwdriver to gain access to the filter.
• Check operation of spray control - Push diagnostic button in equipment room to run test on
all functionality of pet wash.
•
Check the two HVAC filters if applicable - Slide filters up by grabbing lower section and
lifting up then pulling out.
•
Check under rubber mats in wash tub (floor and tub)
- Depending on climate, remove
rubber mat and hang dry nearby.
MONTHLY MAINTENANCE SCHEDULE
• Rinse the hair strainer
- Remove excess hair and clean the strainer.
• Clean glass with Glass Stripper
- Work in Glass Stripper with microfiber towel. Rinse with
water afterwards.
AS NEEDED MAINTENANCE SCHEDULE
•
Check and replace incoming water filter every six months
• Clean bill, coin and credit card equipment
III. DAILY MAINTENANCE SCHEDULE
