ALL-O-MATIC APS1000-12, User Manual

Page: 3 / 24

Important Safety Information
í ! wb Lb Dﱡ
This manual contains important instructions for APS1000-12 & APS2000-24 models that
shall be followed during installation and maintenance of the inverters.
General Safety Precautions
1. Before installing and using the inverter/charger, read all instructions and
cautionary markings on the inverter/charger and all appropriate sections of this
guide. Be sure to read all instructions and cautionary markings for any equipment
attached to this unit.
2. Install this unit away from direct sun light and where is not exposed to water
sprinklers.
3. To reduce risk of fire hazard, do not cover or obstruct the ventilation openings.
Do not install the inverter/charger in a zero-clearance compartment. Otherwise
overheating may occur.\
4. Use only attachments recommended or sold by the manufacturer. Doing
otherwise may result in a risk of fire, electric shock, or injury to persons.
5. To avoid a risk of fire and electric shock, make sure that existing wiring is in good
condition and that wire is not undersized. Do not connect the inverter/charger
with damaged or substandard wiring.
6. Do not operate the inverter/charger if it has received a sharp blow, been
dropped, or otherwise damaged in any way. If the inverter/charger is damaged,
read the warranty section.
7. Do not disassemble the inverter/charger. It contains no user-serviceable parts.
See warranty for instructions on obtaining service. Attempting to service the
inverter/charger yourself may result in a risk of electrical shock or fire. Internal
capacitors remain charged after all power is disconnected.
8. The inverter contains more than one live circuit (batteries and AC line). Power
may be present at more than one source. To reduce the risk of electric shock,
disconnect both AC and DC power from inverter/charger before attempting any
maintenance or cleaning or working on any circuits connected to the
inverter/charger. Turning off controls will not reduce this risk.
9. Use insulated tools to reduce the chance of short-circuits when installing or
working with the inverter or the batteries.
Precautions When Working with Batteries
1. Make sure the batteries are well ventilated. Avoid blocking enclosure vents.
2. Never smoke or allow a spark or flame near the inverter or batteries.
3. Use caution to reduce the risk of dropping a metal tool on the batteries. It could
spark or short circuit the battery or other electrical parts and could cause an
explosion.
4. Remove all metal items, like rings, bracelets, and watches when working with
lead-acid batteries. Lead-acid batteries produce a short circuit current high
enough to weld metal to skin.
5. Make sure someone is close enough to aid should anything dangerous occur
when you’re working near a lead-acid battery.