12
5
Basic Operations
New channel
(1)
Enter radio Menu-Settings-Chan Set-New Chan.
(2)
Input the channel number and name.
(3)
Select a zone from zone list, then Confirm To Save. The radio will start
channel saving, and saving is completed when it displays "Saved".
(4)
Now select the new channel in the radio and go to Channel Settings
menu to set up all the new channel's parameters.
The temporary call will be droped when the digital hold time is expired
and the radio will return to the preset TG/DMR ID in channel.
Delete Channel
Enter radio Menu-Settings-Chan Set-Delete Chan, it allows to delete the
current channel.
Receiving and Responding to a Radio Call
When the radio is in the digital mode, it can receive and respond to a call
with the same frequency/color code/ slot. When receiving a call:
a.
If the radio is programed with callers DMR ID number in the digital
contact list, when receiving a call, the radio will ring or vibrate briefly.
b.
The blue LED lights up.
c.
The left top corner of LCD shows the RSSI icon, and the LCD display
will show DMR ID/name/city/state/country/call type and incoming icon
based on what is in the contact list.
d.
When the call is ended, it will display “Call end”, and you can press
[PTT] to respond the call. Make sure to respond the call within the
digital hold time, otherwise the radio will drop the connection after the
digital hold time is expired.
Make a Digital Call
A. Talk to the preset TG/DMR ID in channel
Choose a programmed channel and press PTT to start the call.
B.
Talk to a temporary TG/DMR ID not in the channel
Method 1:
Select a temporary TG/DMR ID from the Talk Group list.
(1)
Choose a programmed channel.
(2)
Press [EXIT] key to enter the TG List, turn the channel switch or press
the UP/DN key on microphone to choose a TG/DMR ID.
Method 2:
Select a temporary TG/DMR ID from the keypad.
(1)
Choose a programmed channel.
(2)
Press [Menu] key to Talk Group, select Manual Dial.
(3)
Input the ID number by keypad on microphone, press [#] key to switch
group ID or Private DMR ID.
Press the [PTT] key to start the call, the red LED lights up, the receiver
ID/name/city/state/country/call type and call out icon will be display on
the LCD. Release [PTT] key to receive the reply.
When in analog mode, if no signal, it will emit noise when press the
Monitor Key. ** The Rx icon is seen when monitor is activated.
Monitor
In standby, press the programmed [Monitor] key to enter Monitor. When
receiving matched carrier but the signaling / ID is unmatched or the
signal is too weak, this function allows monitor the weak signal and
signal with unmatched ID. Press the key again to shut off speaker and
return to standby.
Emergency Alarm
Press the programmed [Emergency Alarm] key to turn on alarm function,
then press this key again to return.
