57
5. Speed:
Adjusts the movement speed of the PTZ.
6. Light:
Turns PTZ light (if applicable) on and off.
7. Wiper:
Turns PTZ wiper (if applicable) on and off.
8. Zoom
In:
Instantly zooms PTZ in.
9. Center:
Centers PTZ.
9.3.1 Customising
Presets
Presets can be set to move your PTZ camera to a desired
preset
location.
To set up and call custom PTZ presets:
1.
Enter the PTZ Control interface, shown in Figure 3, by selecting PTZ
from the mouse menu or clicking the
PTZ
button on the front panel.
2.
Select the
Preset
button to enter the Preset Management menu.
3.
In the Preset Management menu, shown in Figure 4, you may:
•
Configure Preset:
Use the PTZ control panel to adjust the position of
the preset. Select a Preset number and click the
Set
button to save
preset location.
•
Clear Preset:
Select a Preset number and click the
Clear
button to
delete the preset. You may also select the
Clear All
button to delete
all presets.
•
Call Preset:
Select a Preset and click the
Call
button.
Figure 4. Preset Management Menu
Note:
Only valid presets can be called and deleted
.
9.3.2 Customising
Patrols
Although Patrols or Tours can be setup using the Patrol option, this option
applies only to certain manufacturer’s equipment. It is advised to follow the
instructions as detailed in the PTZ camera instructions.
Patrols can be programmed to move the PTZ to different key points and make it stay
there for a defined duration before moving on to the next point. The key points are
defined by presets which can be set by following the steps above in
Customise
Presets
.
