28
Version 1.01
File management
ID files
Some engine control units do not support reading via OBDII diagnostic connector. If you want to
reprogram these units, you must:
1.
Perform the ID procedure and save the encoder file with the identification data of the ECU on
your computer.
2.
Send this file to your Master.
Modified files
As specified in the section
Glossary (page
4
)
, a Slave tool allows you to read encoded files from the
engine control unit and write only encoded files received from your Master.
Also to rewrite the original file or restore the backup file you need to ask your Master for the
validation of these files.
In order to program a vehicle, it is necessary to perform the following steps:
1.
Red the encoded file from the ECU. If the ECU does not support the reading, perform the ID
procedure.
2.
Send the file read to your Master.
3.
Save on your computer the encoded modified file received from your Master.
4.
Write the file to the ECU.