19
2375 ·
Stand/Update: 03.2021
EN
5.
Scraping of pipe surface
fig. 5
• Evenly rotate scraper tool by ball
handholds
(4) in direction shown
(note arrow
(10)) around the pipe
(see fig. 5).
• Continue scraping until the pipe
area marked has been completely
scraped.
INFORMATION
Scraping the outlet spigot of saddle fittings!
Should the scraped length be too short, the scraper tool must be turned and again
clamped to the outlet spigot. Scraping is then performed in the opposite direction
towards the face side. Scraping must stop as soon as it overlaps the previously
scraped spigot area – at most by one turn. At this position, the scraper tool’s front
guide wheels may not function properly.
CAUTION
Risk of injury during scraping process!
Keep hands off the pipe.
NOTICE
Do not push the tool in the direction of the axis of the pipe whilst scraping!
• The swarf is to be removed manually.
