AVF7000 Operation Manual
OP7000.1.1.7.R12ENG
12
8. Panel Display
9. Function
9.1 Button Function
Key
Button
Function
Setting
SE T
SE T
Press shortly (1s) to enter menu settings or exit settings.
Move
Press shortly (1s) to shift to page down or move digit position when set parameters.
Up
Press shortly (1s) to shift to page up or
increase value by “1” when set parameters.
Press long for 3s to enter chosen menu settings or confirm.
9.2 Display Function
In normal display interface, press
shortly (3s) and check frequency, density, pressure, temperature, current
percentage …as below:
Symbol F: Den: P:
T:
Curr: Per:
P&T
Content Frequency Density Pressure
Temperature
Current Percentage
Temperature
Pressure
Other display:
If enable pressure auto acquisition and pressure signal is abnormal, the pressure value in “Temp.&Pressure”
interface will flash.
If enable temperature auto acquisition and temperature signal is abnormal, the temperature value in
“Temp.&Pressure” interface will flash.
.P and T Shows the preset pressure and temperature of circuit board
,
P&T Shows the pressure and temperature
value from sensor
10.5 m3/h
E 20.0 m3
10.5 m3/h
E 20.0 m3
P=12.5Kpa T=20.0
℃
2_Line Display Mode
LCD only displays flow rate and totalizer.
3_Line Display Mode
LCD displays flow rate and tot frequency / density / pressure / temperature / current
/percentage/ P&T.
Press
button to choose pressure, temperature, density, current and percentage……
10 3m3 h
.
/
