µISP User's Manual
7
Connectors Overview
µISP has several connectors for interfacing to a host PC, to an Automatic Test
Equipment (ATE), and to the target system(s) to be programmed. The following
pictures show where the various connectors are located.
▪
The USB connector is used to communicate with a host PC system. µISP
can also be powered by this USB type C (5V) port.
▪
The LAN connector is used to communicate with a host PC system.
▪
The multifunctional STATUS LED shows the status of programmer and the
result of the project execution.
▪
The START button executes the programming process with the last
downloaded project.
▪
The ISP connector is used to interface to the target system(s) to be
programmed.
▪
The CONTROL connector is used to interface the instrument to an ATE or
other systems. After the configuration of the parameters, the programmer
can be controlled by I/O lines (START, BUSY, PASS/FAIL).
For details and pinout of the various connectors, see the
“Connectors” chapter.
START button
STATUS LED
LAN
USB
CONTROL
connector
ISP connector
