Wireless Timing Network WTN-PB
-6-
3.3 Team
This function is to select the team number of a WTN system. You can select be-
tween 15 team numbers. There are 9 single teams (1-9) and 6 common teams (A-
F). To adjust the team numbers, use a small screw driver. Position 0 is an internal
factory test mode and has no function for the user.
Separate Teams = SINGLE
Used for completely independent networks. If you operate two networks next to each other
both networks work in this mode on different frequencies and do not communicate among
each other.
Joint Teams = ALL
Used for networks that work independently next to each other. If different A teams with the
same radio channel are operated, the other A teams can be used for data transmission. The
data of the other team however is not used (e.g. for two show jumping grounds that are next
to each other).
Adjustment:
The rotation switch to adjust the teams is hidden in the battery
compartment in order to prevent changes that are not wanted.
In order to change the team, it is necessary to open the battery
compartment and remove the battery. For the adjustment a
small screwdriver is necessary (delivered by ALGE-TIMING
with the WTN-PB).
3.4 Factory Setting
If you want to set the WTN-PB to factory settings you can make a reset:
•
Hold down the button for 10 seconds when switching on.
•
Both LEDs shine red.
•
The WTN-PB will be set to factory setting: Timing channel C1
•
Release the button and the WTN-PB returns to normal operation mode.
In the normal operating mode, you can trigger a timing event by a short press to the button.