Wireless Timing Network WTN-PB
-5-
2
Initial Operation
For the initial operation you have to remove the transportation lock. For this you remove the
battery cover and remove the plastic coating. Close the battery cover. The WTN-PB is now
ready for operation.
Re-insert this plastic coating for transportation.
Please remove the battery if you do not use the WTN-PB for a longer period.
3
Operation
3.1 Switch On / Switch Off
•
Switch on:
press the red button shortly, both LED must blink green
•
Switch off:
keep the red button pressed for 5 seconds until the both LED show per-
manent red
3.2 Timing Channel
You can setup the timing channel as follows:
•
Hold down the button for 5 seconds when switching on.
•
Both LEDs shine green.
•
Release the button. Now the channel is set co C0.
•
Other channels you can setup by pressing the button. Once for C1, Twice for C2, …
•
If you do not press the button for 5 seconds the WTN-PB returns to normal operation
mode. The chosen channel will be stored even when you switch the device off and on
again.
3.2.1
Adjust Channel 0
•
WTN-PB must be switched off
•
Press button of WTN-PB for about 5 seconds until both LED show permanent green
•
Release button and wait until both LED blink green
•
Channel 0 is adjusted
3.2.2
Adjust Channel 1
•
WTN-PB must be switched off
•
Press button of WTN-PB for about 10 seconds until both LED show permanent red
•
Release button and wait until both LED blink green
•
Channel 1 is adjusted