ALGE-Timing BANG2, Manual

Page: 8 / 16

Manual
Speaker System BANG2
-8-
2.4.1 Start Unit SU2 or SU3
The Start Unit SU2 or SU3 can be con-
nected at the LTW-sockets (1) using cable
199-xx. Use the integrated microphone of
the SU3 or headset HS3-2 to output com-
mands for the athletes via loudspeaker
box BANG2. Furthermore, communicating
with the timing person with headset via
start line is possible.
2.4.2 Speech Amplifier SV4-S or SV4/SM
You can connect a speech ampli-
fier with headset at the banana
sockets (2) for communicating with
the timing person. This also re-
quires installing a two-wire line
from banana sockets to timing.
2.5 Audio Connections
2.5.1 Inputs
Possible sound sources could be a microphone and a stereo device with line output level:
•
microphone either via XLR- or 6.3 mm jack plug to the symmetrically wired socket MIC
IN (16)
•
stereo device with line output to the Cinch sockets LINE IN (13)
2.5.2 Output LINE OUT
The Cinch sockets LINE OUT (14) can be used for e.g. a recording device or an additional
active box BANG2 for sonication. Both sockets output the mono mix signal of the box. The
controller MASTER (12) for total volume of the active box does not influence the signal at
output LINE OUT but the settings of the tone controller TREBLE (6) and BASS (7).
2.5.3 Passive Loudspeaker Box
If an additional loudspeaker box (without amplifier) is required for sonication, it is connected to
the socket SPEAKER (15). The impedance of the loudspeaker box must at least be 8
Ω.
ALGE-
TIMING
offers BANG SPK as accessory. Up to eight 8 BANG SPK can be connected.