INTRODUCTION
The DMX distributor offers one input and four outputs. Both inputs and outputs as well as outputs among each other are com-
pletely eclectically isolated. Each DMX output features an independent driver and DATA+ & DATA- indicator. Using the
built-in switch you can easily terminate the LINK OUT, when you don’t want to transmit the DMX signal to other units.
OPERATING INSTRUCTION AND CONNECTION
Out
In
DMX Distributor
DMX Controller
In
In
Out 1
Receiver
Receiver
Receiver
Receiver
Out 8
Receiver can not more than 32 units on one out channel.
Use one terminator on the last receiver
DMX OUT: connect the DMX receiving device(s) here
DMX IN: connect the DMX transmitting device here
You can run a maximum of 32 units (receiver) per output channel.
Use a terminator on the last receiver.
If you don’t connect other units to the DMX LINK OUT socket, you have to press the switch underneath the
socket, to terminate this output.
You may only connect the device to a properly wired and earthed mains power wall outlet, after all DMX
connections have been established. The wall outlet must provide the correct mains voltage as stated in this
manual.
