English
English
1
Components
5
2
Assembling your eleCtriCAl AlArm
3
4
Batteries Required: 2 X AA (not included)
1. 1 x Siren Cover
2. 1 x Plastic Cone
3. 1 x LED Light
4. 1 x Siren Body
5. 1 x Gear Cover
6. 1 x Motor
7. 1 x Switch Plate
• On the Base Plate (12), install the Spring Connectors (11) at position (3), (4), and with the Switch Plate
(7) at position (1) and Metal Plate (8) at position (2) narrow end down, push the spring as far as it will
go. Make sure the switch is closed by itself. Connect the red battery wire to the spring connector at
position (1) and black battery wire to position (4) as shown (Fig. 2). Bend the spring over to create a gap
into which the metal wire is inserted.
• Install the Resistor (10) by connecting its wires to the spring connectors at position (2) and (3) as shown
in Fig. 4.
• As shown in Figure 3, connect the Buzzer (9) to the spring connectors as follows: Buzzer red wire – 2
Buzzer black wire – 4
8. 1 x Metal Plate
9. 1 x Buzzer
10. 1 x Resistor
• As shown in Fig. 5, install the Motor (6) and LED Light (3) to the Siren Body (4). Make sure the wires go
through the corresponding holes at the bottom.
11. 4 x Spring Connectors
12. 1 x Base Plate
13. 1 x Plastic Tag
1
Colours and contents may vary
