page | 10
Filter-Reset
The antibacterial filter unit should be replaced after 4.320 operating hours. This is
indicated by flashing of the "FILTER RESET" LED. To reset the operating hours
counter, press and hold the power button for 3 seconds until a signal sounds.
If you want to replace the filter unit prematurely, you can reset the operating hours
counter manually. To do this, press the power button for 5 seconds, the "FILTER
RESET" LED will start flashing. Press the power button again for 3 seconds until a
signal sounds.
How to replace the filter unit is described in the following chapter.
CLEANING / MAINTENANCE / FILTER CHANG:
Proceed as follows to clean the appliance:
1.
Switch off the unit and unplug the power cord.
2.
Lift the upper housing and remove it from the water tank.
3.
Now remove the filter unit including float and float holder.
4.
Clean the water tank with warm water and a soft cloth.
5.
Replace the antibacterial filter unit, float and float holder properly and place
the upper housing back on the water container. Pay attention to a safe and
correct hold.
Cleaning the housing
Clean the housing of the humidifier with a slightly damp cloth.
Useful cleaning instructions:
Use a solution of 50:50 water and vinegar or a 3:1 solution of water and vinegar
essence. Do not use abrasive or corrosive cleaning agents.
Summary of Contents for ALB300
Page 1: ...USER MANUAL ALB300 HUMIDIFIER...
Page 7: ...page 7 COMPONENTS...
