3
Introduction
The pack M4 contains a display model ADM (medium) and a box ABX4.
The pack M4GPS has the same display but a box ABX4GPS, this box is integrated with a GPS
module that obtains the speed, track mapping and GPS timing.
These boxes have 4 connectors :
1)
Timing : magnetic/infrared
green connector
2)
Temperature (T1) / Lambda
red connector
3)
RPM (HighandLow tension PRW)
yellow connector
4)
BUS (to connect the display)
black connector
The pack M4/M4GPS is delivered with a magnetic sensor ref.A1301, a RPM engine sensor
ref.A1601, a BUS cable ref.A3101 allowing the connection between the box and its display,
box support fittings, the batteries and an USB Bluetooth adapter for the download of your
data and system firmware update.
The transfer of data to the computer is made via the integrated Bluetooth module.
Installation
CORRECT
The BOX must be fixed below the Nassau
panel like this drawing
NOT CORRECT
The BOX cannot be installed on the floor!
Important information
- Insert the male connector all the way before tightening the nut.
- Use a sparkplug or an anti-interference sparkplug boot equipped with a 5 Ohms
minimum resistance for an optimal system performance.
- The installation is finished; re-start the system so it can recognize the connected sensors.
- Use a Torx X20 screwdriver to tighten the battery cap.
