8
Outputs terminal block (X4)
Outputs for 24VDC loads. For inductive loads such as valves and relays, it is necessary to have a
diode parallel to the coils to eliminate peaks in voltage.
Nome
Morsetto
Default
Output 0
X4.1
GOOD
0V
X4.2
Negative power supply
Output 1
X4.3
REJECTED 1
Output 8
X4.4
Output 2
X4.5
PRESS
Output 3
X4.6
PROTECTION
Output 4
X4.7
CONTACT/BOOSTER
Output 5
X4.8
Output 6
X4.9
Output 7
X4.10
The function of each output is configurable. Each output can have one of the following functions:
Name
Default Function
GOOD
0
Good piece signal. Active after the return of the cylinder until the next
start.
REJECTED 1
1
Normal rejected piece signal. Active after the return of the cylinder until
the next start. The output is intermittent until the reset signal.
REJECTED 2
7
Special rejected piece signal. Active after the return of the cylinder until
the next start. The output is intermittent until the reset signal.
REJECTED AUTO-CHECK
Auto-check sample piece signal. Active after the return of the cylinder
until the next start. The output is intermittent until the reset signal.
PRESS
2
Enables the press. Active after the start if the instrument is ready and
deactivated upon reaching the stoppage value.
DOOR
3
Command for the closure of the protection
BUZZER
4
Command for the closure of the acoustic signal.
TEST OUTPUT
6
Activation of external measuring TEST SIGNAL 1
CONTACT/BOOSTER
Contact to piece or start working stroke
CHECK POINT OUT #
Output activated at a programmable position (up to 3 outputs)
PHASE BIT 0
Active when working the phase 2 or 4
PHASE BIT 1
Active when working the phase 3 or 4
MANUAL
Active when you choose a job that is not a selectable job
BRAKE
Output for a brake to reduce speed
ENABLE RETURN
5
Enable return of the cylinder when detecting a good piece or after reset
ENABLE MANUALE
Control for electric lock lever on mechanical presses
OPEN GREEN BOX
Command for opening basket of the good pieces
CLOSE PK TANK
Closing command of the tank on the Alfamatic PK cilinders
BLOCK OF THE TABLE
Block piece for work
PULL LEVER
Cylinder control help return cylinder (for heavy tools)
RESET DRIVER
Driver reset fault (servo presses)
ENABLE DRIVER
Driver enable (servo presses)