7/37
ALFA IN a.s ©
www.alfain.eu
17.
Exceeding the concentration of these gases above the values given
by hygienic standards can cause damage to health, especially with
prolonged exposure.
18.
Workplaces must be well ventilated and equipped with an effective
extraction system.
19.
In addition, a breathing mask must be used when cutting material
where particularly hazardous fumes are generated.
20.
During its operation, the machine produces noise, the level of which
reaches the value of 80-85 dB.
21.
We recommend using hearing protection for longer work.
PROHIBITED ACTIVITIES
1. It is forbidden to use the machine in areas with a risk of explosion and in
areas with the possibility of easily flammable and flammable substances.
2. It is forbidden to cut containers with residues of any flammable or unknown
substances.
3. It is forbidden to cut on closed pressure vessels without first releasing the
pressure and leaving it open.
3. CONDITIONS OF USE
1. 1st Putting into operation may only be performed by trained personnel and
only in the technical provisions. The manufacturer is not liable for damage
caused by improper use and operation. Only use original spare parts from
ALFA IN for maintenance and repairs.
2. The device complies with IEC 61000-3-12.
3. The cutting machine is tested according to the standard for degree of
protection IP 23 S, which provides protection against the ingress of solid
bodies with a diameter greater than 12 mm and protection against the
ingress of water falling in a vertical to oblique direction up to 60
4. Working ambient temperature between -10 and +40 °C.
5. Relative humidity below 90% at +20 °C.
6. Up to 3000 m altitude.
7. The machine must be positioned so that cooling air can enter and exit the
cooling vents without restriction. Care must be taken to ensure that no
mechanical particles, especially metal particles, are sucked into the
machine (during grinding).
8. When the machine overheats, cutting is automatically interrupted.
9. All interventions in the el. equipment as well as repairs (disassembly of the
mains plug) may only be carried out by an authorized person.
10.
SVAROG 85 PLASMA is designed for mains voltage 3x400 V.
11.
The mains voltage and power input must correspond to the mains
plug.
12.
For the cutting machine, it is necessary to perform a periodic
