Alfa Romeo MiTo 2016, Owner'S Handbook Manual, Page: 31 / 212

ELECTRIC WINDOWS
15)
2)
These operate when the ignition key is
turned to MAR and for about 3 minutes
after turning the key to STOP or
removing it if one of the doors is open.
Anti-crush safety device
An anti-crush device is operated when
the windows are lifted. This safety
system detects the presence of an
obstacle during the window closing travel
and cuts in by stopping and reversing the
window travel, depending on its position.
The anti-crushing feature is active during
window manual and automatic operation.
CONTROLS
Driver side door
1 fig. 27: front left window
opening/closing
2: front right window opening/closing
Window opening
Push the buttons to open the desired
window. When one of the two buttons is
pressed briefly, the window moves in
"stages"; if the button is held down,
"continuous automatic" operation is
activated. If the button is pressed again,
the window will stop in the desired
position. If the button is held down for
several seconds, the window raises or
lowers automatically (only with ignition
key in MAR position).
Window closing
Lift the buttons to close the desired
window.
Passenger side door
The passenger side door is equipped with
a button that controls the
opening/closing of the passenger side
window.
Electric window system initialisation
The system must be re-initialised after
disconnecting the battery or if the
relevant protection fuse is blown.
Perform the following initialisation
procedure:
fully close the window to initialise
manually;
after the window has reached the
upper end of travel, hold the up button
pressed for at least one second.
On some versions/markets, after there
has been no power supply for the control
units (battery replaced or disconnected
or protection fuses for the electric
window control units replaced), the
automatic operation of the windows
must be restored.
The restoration procedure must be
performed as described below with the
doors closed:
completely open the driver's door
window keeping the operating button
pressed for at least three seconds after
the (lower) end of travel position is
reached;
completely raise the driver side
window and hold the button down for at
least 3 seconds once the (upper) end of
travel position has been reached;
repeat stages 1 and 2 also for the
passenger's window;
27
A0J0023C
29