5. Operation
10
Pay attention to possible faults
Read the instructions carefully.
5.2
Trouble Shooting
Yes
No
Does Rotor (pos.
10) turn freely by
hand?
- Cracked Input Pinion (pos. 51) - Section 6.4 Inspection and Service of Components
- Damaged planetary gearhead (pos. 26) - Section 6.4 Inspection and Service of
Components
- Damaged Rotor Shaft Housing O- Ring (pos. 54) - Section 6.4 Inspection and Service
of Components
- Bent stem (pos. 3) - Section 6.4 Inspection and Service of Components
No
Yes
- Loose output shaft set screw (pos. 39) - Section 6.4 Inspection and Service of
Components
- Cracked/Loose Input Pinions (pos. 51) - Section 6.4 Inspection and Service of
Components
- Worn gear bushing (pos. 31) - Section 6.4 Inspection and Service of
Components
- Worn output shaft lower seal (pos. 25) - Section 6.4 Inspection and
Service of Components
- Worn Tee & Nozzle housing bearing (pos. 35, 36) - Section 6.4 Inspection and
Service of Components
- Bent stem (pos. 3) - Section 6.4 Inspection and Service of Components
- Loose nozzle & tee bearing cup (pos. 32, 34) - Section 6.4 Inspection and Service
of Components
Do Nozzle (pos.
5)
and
Tee
Housing
(pos.
4) both index
when
Rotor
(pos.
10)
is
turned?
Yes
No
Does only Tee
Housing
(pos. 4) index?
- Worn Tee/ Nozzle housing bevel gear (pos. 17, 18) - Section 6.4 Inspection and
Service of Components
- Broken Drive Pin (pos. 45) - Section 6.4 Inspection and Service of Components
- Worn rotor shaft bearing O- Ring (pos. 49) - Section 6.4 Inspection and
Service of Components
- Cracked/Loose input pinion (pos. 51) - Section 6.4 Inspection and Service of
Components
- Very loose output shaft set screw (pos. 39) - Section 6.4 Inspection and Service of
Components
