-3-
ALFA IN a.s. ©
www.alfain.eu
1
INTRODUCTION
Congratulations on your new ALFA IN product. We are proud to have you as
our customer and will strive to provide you with the best service and reliability
in the industry.
This Operating Manual has been designed to instruct you on the correct use
and operation of your ALFA IN product. Your satisfaction with this product and
its safe operation is our ultimate concern. Therefore please take the time to
read the entire manual, especially the Safety Precautions. They will help you to
avoid potential hazards that may exist when working with this product.
Read and understand this entire Manual and your employer’s safety practices
before installing, operating, or servicing the equipment. While the information
contained in this Manual represents the Manufacturer's best judgement, the
Manufacturer assumes no liability for its use.
PEGAS 160 E PFC welds by those methods
a)
E – (MMA) coated electrodes up to 4,0 mm
b)
TIG lift arc.
PEGAS 160 E PFC is equipped by system of Power Factor Correction (PFC)
– which enables operating on AC power supply of 95V – 270V.
What are the advantages of PFC solution?
•
Higher efficiency and less stress related to the circuit breaker (in other
words, circuit breaker will switch off later than the devices without PFC)
•
The machine can be connected to the mains 110 V - 230 V + -15% Small
influence of under voltage and overvoltage mains power
•
Smaller level of electromagnetic interference
•
Minimum net reactive current loading
2
SAFETY INSTRUCTIONS AND WARNINGS
•
Once the packing has been opened, make sure that the machine is not
damaged. If in any doubt, call the service centre.
•
This equipment must only be used by qualified personnel.
•
During installation, any electric work must only be carried out by trained
personnel.
•
The machine must be used in a dry place with good ventilation.
•
Make sure that no metal dust can be drawn in by the fan inside the
machine, as this could cause damage to the electronic circuits.
•
It is prohibited to connect more than one INVERTER generator in series or
in parallel.
