6
MAC
Once Cubase LE 6 is installed and activated, follow the
steps below to configure the software to record with the
mixer.
1.
Open Cubase LE 6. If prompted to open a
project, cancel for now.
2.
From the menus, select
Devices
Device
Setup
.
3. In
Device Setup
, click on
VST Audio System.
4.
In the ASIO driver list on the right side of the
Device Setup
, select
USB Audio Codec
. Click
OK
.
5. Select
USB Audio CODEC
from the left panel
and click on the
Control Panel
button at the top
right of the window. Ensure that
USB Audio
CODEC
is selected for the Input/Output
Configuration device. Uncheck any other devices
listed here.
6.
In Cubase, click on
File
New Project
and
select
Empty
, and choose where you would like
to save your project.
7. Click
on
the
Device
menu at the top of the
screen and select
VST
Connections
. Click on
Inputs
at the top of the window. Click on the
input titled under the
Bus Name
column. Create
a Stereo input bus by clicking on the
Add Bus
button and selecting the Stereo configuration.
Name the preset, and click
OK.
8. Under
the
Audio Device
column, select “USB
Audio Codec”.
9.
In the Device port column, select "Front Left" for the Left stereo input and "Front Right" for the right stereo
input.
10. Click on the
Outputs
tab, select your output device in the exact same way you set up your input device as the
Audio Device.
11. Close
the
VST Connections
window.
12. Right click in the dark blue area of the main project and choose
Add Audio Track.
13. In the Audio Track Configuration window, select 1 – Stereo and click
OK.
14. Activate
the
Track Monitor
button on the Stereo track, found next to the Record Enable button. Click the
Record button at the top of the Cubase window, do a quick test, and stop the recording.
15. Rewind to the beginning of the track, disable the track monitor button and then press the play button at the top
of the Cubase window to hear what you just recorded.
Note
: To avoid having to set the VST Audio System and VST Connections each time you open Cubase, you can
save a your settings as a template by going to File Save as Template. Then when you reopen Cubase your
template will appear in the Project Templates list.
REAR PANEL FEATURES
1.
POWER IN –
Use the included power adapter to connect the MultiMix 16 USB FX to a power outlet. While the
power is switched off, plug the power adapter into the MultiMix 16 USB FX first, and then plug the power
adapter into a power outlet.
2.
POWER SWITCH –
Turns the MultiMix 16 USB FX on and off. Turn on the MultiMix 16 USB FX after all input
devices have been connected and before you turn on amplifiers. Turn off amplifiers before you turn off the
MultiMix 16 USB FX.
3.
PHANTOM POWER –
This switch activates and deactivates phantom power. When activated, phantom power
su48V to the XLR mic inputs. Please note that most dynamic microphones do not require phantom
power, while most condenser microphones do. Consult your microphone’s documentation to find out whether it
needs phantom power.
4.
USB PORT –
Use the included cable to connect the MultiMix 16 USB FX to a computer. MultiMix 16 USB FX
requires a USB 1.1 or higher (e.g. USB 2.0) connection.
2
3
1
4
