Pager Charging
The pager’s battery should last approximately 3 days depending on how many
alarm cycles it goes through during this period.
When the pager’s battery starts to get low the green Pager LED (Figure 2) will
start to flash every second indicating the pager should be plugged into the
provided charger. When the battery is very low, the pager will sound every
minute.
The Pager LED will blip off every 8 seconds during boost charge and will be solid
green when the battery is approaching full charge.
Charge for at least 12 hours.
Pairing Instructions
The monitor will usually be paired to the pager before it is shipped to you. If this
is not the case, the instructions below will show you how to pair them together.
Pairing the Monitor to the Pager
Ensure the monitor is turned on. Pairing is only possible within 30 seconds of
powering up the pager. To pair the Monitor to the Page; place the monitor close
to the pager and press and hold the Pair button on the pager. Stimulate any
radio transmission from the monitor. e.g. Pressing a reset button or triggering
an alarm. Or you could wait for the 8 second Safelink® signal. If successful you
will hear a beep and see the red Monitor LED blip when pairing is successful, you
can then release the pair button. A lower burp with no red light indicates the
monitor is too far away to pair. This protects against falsely pairing with anoth-
er, distant, monitor
To clear all paired monitors from the pager memory, press and hold both the
ON/OFF button and the Mute/ Pair button together within the first 30 seconds
after power-up, until the ensuing tone sequence has finished sounding and the
green Pager LED lights, then release both buttons.
Page | 10
