MinkPolice User Manual
EN - 8
Troubleshooting
12
There are three basic steps that should be followed if a module does
not work as expected.
Step 1
-
Activate the magnetic switch in the box by either taking the
magnet off or placing it on the red line. You should now hear a
long beep. If you hear no sound, go to Step 2.
-
Wait for one of the following signals from the module (please wait
up to several minutes):
x
Two long beeps: The module connected to the server
successfully
–
everything is OK.
x
Three short beeps: The module did not connect to the
server.
In Step 3, you can see all possible reasons for unsuccessful attempt
to connect to the server.
Step 2
-
Reset the module. This is done
by placing the magnet on the
side of the module on top of the
SIM card holder (see picture).
-
Hold the magnet holder on the
box for three seconds, and the
module will give off a long beep.
The module is now reset.
-
Go to Step 1 and see if the
module will connect to the server as expected.
Step 3
-
If the module still gives off three short beeps (i.e. connection
attempt failed), you may try to move the module to a location
where network reception is known to be good (e.g. a place where
it has previously connected successfully) and try again.
