www.aleratec.com
6
Using the HDD Copy Dock Duplicator
Loading Hard Drives
1. Use the included power adapter and cord to plug the HDD Copy Dock Duplicator
into a power outlet.
2. Insert the SATA Hard Drive you want to copy into the slot marked “SOURCE
DISK 4”. When inserting, align the SATA port on the Hard Drive with the SATA
connector in the drive bay slot. Press the “SOURCE DISK 4” power button on the
front of the unit to power up the drive.
3. Insert the destination SATA Hard Drives into the slots marked “TARGET DISK 1”,
“TARGET DISK 2” and “TARGET DISK 3”. When inserting, align the SATA port
on the Hard Drive with the SATA connector in the drive bay slot. Press the power
button on the front of the unit to power up the drive target drive(s).
Note:
Make sure the target Hard Drive has the same or higher capacity than your
source Hard Drive. The duplication process will not start if the target drive has
a lower capacity. Also make sure the unit is not connected to a PC through the
USB or eSATA ports.
4. Push the main power button to turn the unit on.
5. Push the
DOWN
button to select the Duplicator Mode menu item and press
ENT
.
Press
ENT
two more times to switch to Duplicator Mode.
The system will auto-detect the hard drives. After the drives have been
detected, a screen similar to the one below will be displayed:
Note:
Before copying be sure that the capacity of the target HDD is equal to or
larger than the source hard drive.
HDD Duplicator
1-1
ver:
UP
DOWN
ENT
ESC
POWER
== Dup. Menu ==
1. Copy HDD
