www.aleratec.com
16
Main Menu
Asynchronous Copy+Compare
Asynchronous Copy+Compare is used only when the source content
is the same as or less than the system buffer (256MB). With the source
content read into the systems buffer you can copy and compare flash drives
continuously by taking out the drive which has finished its Copy+Repair
cycle, and replacing it with another blank. This process is repeated until the
Copy+Compare job is complete.
1. Load the source flash drive into the USB Duplicator. Use the
UP
or
DOWN
arrow to scroll through the menu until Copy+Compare is
displayed on the LCD screen.
2. Press the
OK
button on the display panel. The USB Duplicator will
start to read the source content into the system’s buffer and immediately
start copying any loaded target USB flash drives.
3. Load the blank target flash drives into the USB Duplicator. The LCD
will display the number of blank media loaded and copying.
Note:
When copying is in process the Green LED on the front panel is
blinking. Do not take out the drive while it is copying. When copying is
finished the Green LED stays on (no blinking). If an error occurs during
the copy process a Red LED will display.
USB(58M) 450M
Reading...
ESC
OK
ESC
OK
USB Duplicator
3. Copy+Compare
Pass: 0
Working
Fail: 0
3
ESC
OK
ENT
ESC
ENT
ESC
ENT
ESC
