Locking Tab
Can be adjusted open or closed to ease assembly
Quick Assembly Bookcase
Assembly Instructions
TIPS FOR EASIER ASSEMBLY:
Page 2
Step 1
-
Back Assembly
A)
Lay the two back panels on a flat
surface. Position as illustrated.
B)
Place the Right Back Panel (D) over the
Left Back Panel (C) inserting the tabs into the
matching holes.
C)
Once all the tabs are started, slide the Back Panels
in opposite directions to
fully engage
the tabs.
D)
Tap the tabs down
with a rubber mallet to
tighten the connections.
Left Back Panel - C
Right Back Panel - D
Square
Holes
Tabs
Bend is up
Bend is up
Right Back Panel
Left Back Panel
Insert the tabs into the matching holes
Step 2
-
Side Assembly
• 2-person assembly is recommended.
• Assemble the unit on a flat surface.
• Some locking tabs may flatten out or bend open during transport.
Adjustments can easily be made using a small blade screwdriver with light pressure.
Lift the edge of Back Panels
and set them over the Sides,
inserting the tabs through the
matching square holes.
IMPORTANT:
Make sure the bends on the Side
Panels are on the same side
as the Back Panels
Right Side Panel - B
A)
While the Back Panels are still lying on a
flat surface,
lift the outside edge of the
Right Back Panel (D) and slide the L-shaped
bend of the Right Side Panel (B) under it.
B)
Insert the tabs on the Right Back Panel (B)
into the matching square holes in the
Right Back Panel (D).
C)
Once all the tabs are started, slide the Side
and Back Panels in opposite directions to
fully
engage
the tabs.
D)
Tap each of the tabs down
with a rubber mallet to
tighten the connections.
E)
Repeat the steps with the Left Side Panel (A).
Square
Holes
Square Holes
on Back Panels
Right Back Panel - D
Tabs
on Side Panels
Left Side Panel - A
(shown transparent)
Left Back Panel - C
Slide the panels to fully engage the tabs and tap them down
Slide the panels to fully engage the tabs and tap them down
NOTE:
On the 72” and 84” models, use care when handling
the Back Panels. They bend very easily if not handled properly.
Use
2 hands
and
NEVER
put your fingers in the slots.
When lifting, position
both
hands near the center
of the Back Panel as shown to avoid bending it
