Model: ALE-HT3SAB
4-Position Memory Control
CAUTION
Please orient the table so the plug (from the control box) is closest to the wall outlet
MEMORY CONTROL
OPERATING INSTRUCTIONS
3. SETTING & USING MEMORY PRESET POSITIONS
•
Operate the desk to preferred height.
•
Press any of
① ② ③ ④
together with or for
2 seconds to store the current height. Display shows
P1/ P2/ P3/ P4 when the position has been stored.
•
To return table/desk to a stored position, press the
memory preset button
① ② ③ ④
and the desk will
move to the stored height.
•
Memory presents can be overwritten with a new
position at any time.
1. RESET ***PERFORM RESET BEFORE 1
ST
USE***
•
Press both and buttons at the same time until
both columns are in lowest position.
•
Display will show “000” while conducting reset.
•
When control box beeps, the buttons can be released
and reset is complete.
•
The anti-collision feature will be functional after reset.
2. NORMAL OPERATION
•
Press any button and display shows current height
in centimeters (cm).
•
Press or button to adjust the height.
•
When no button has been pressed for 30 seconds,
the system goes to <0.1 W standby mode, and the
display turns off. Press any button to wake the
system and display the current base height.
4. CHANGING STARTING HEIGHT
•
The default starting height is 25.5”.
•
To adjust the starting height, press button until
reaching lowest position. At the lowest position,
press button again for 5 seconds until display
starts flashing for 10 seconds.
•
During this time, press or buttons to adjust
height to preferred starting position, and then press
and buttons together for 3 seconds to store
this position.
•
Display stops flashing and the new starting height is
shown in the display.
