Alemite, LLC
Revision (2-05)
4
SER 7350
CAUTION
Remove connecting hose pressure before performing the
following procedure.
Replacing The Swivel
Remove connecting hose from swivel.
Remove swivel assembly from inlet shaft.
Install swivel assembly to inlet shaft by reversing steps
1 and 2.
Apply thread compound to all threads.
1.
2.
3.
4.
SERVICE INSTRUCTIONS
Replacing The Delivery Hose
Using a wrench, fi rmly hold on to the connecting tube
assembly while removing hose connector.
Follow procedures for "Connecting The Delivery Hose"
(See Installation Instructions).
1.
2.
Adjust reel drag by loosening or tightening set screw on
hub casting.
1.
Adjusting Reel
Fig. 5
Fig. 6
WARNING-PREVENT STATIC SPARKING
When working around fl ammable liquids such as
solvents, paints, chemicals, or petroleum products,
ensure that the hose reel, hose , and the equipment being
serviced are properly grounded. Use grounded hose(s)
(static wire). Use an ohmmeter to check continuity of
the ground circuit. Fire and/or explosion can result if
proper grounding is not achieved. Pull hose from the
reel by grasping the hose itself, not the control handle or
swivel.
OPERATING INSTRUCTIONS
