Alemite, LLC
Revision (2-05)
3
SER 7350
Apply thread compound to all threads.
Thread male connector of connecting hose into swivel.
Tighten securely.
2.
3.
Two 1/2" (13 mm) diameter mounting holes are located
at the base of each side support panel (2 each). Mount
reel using four (customer supplied) bolts; tightening
them securely to ensure a solid, rigid attachment.
1.
NOTE:
Ensure that mounting surface is fl at to prevent binding
on reel after it is mounted.
Unpack and inspect reel for damage. Turn the reel by hand
to check for smooth operation. Check for completeness.
Inspection
INSTALLATION INSTRUCTIONS
Apply thread compound to all threads.
Hand thread male hose connector into connecting tube
assembly.
Using a wrench, fi rmly hold on to connecting tube assem-
bly while tightening hose connector.
1.
2.
3.
CAUTION
Do not connect the hose to the connecting tube assembly
until after hose reel has been installed.
Fully extend and charge hose before winding on to
reel. Momentarily open control valve, when initially
charging, to purge hose of gases. When fl uid appears at
control valve, close valve. This prevents fl attening of the
hose and excessive pressure on the drum when fl uid sup-
ply is reinitialized at a later time.
Connecting The Delivery Hose
NOTE:
A fl exible hose connection must be used to compensate
for any offset between the supply line and reel swivel.
Fig. 2
Fig. 3
Fig. 4
