41
RAIN
To select the rainfall display mode
Press [ RAIN ] key to toggle between:
1. DAILY - the total rainfall from midnight (default)
2. WEEKLY - the total rainfall of the current week
3. MONTHLY- the total rainfall of the current calendar month
4. TOTAL - the total rainfall since the last reset
5. RATE - Current rainfall rate (base on 10 min rain data)
Period of rainfall and rain rate
In normal mode, press and hold [ Rain ] key for 6 seconds to reset all the rainfall records.
To ensure to have correct data, please reset all the rainfall record when you re-install your wireless 7-IN-1
sensor to other location.
LIGHT INTENSITY & UV INDEX
The UV index and light intensity reading show on the bottom right
side of the display.
The console can show the different reading’s daily MAX / MIN records in memory mode.
To view MAX / MIN records
In normal mode, press [ MEM ] key on the front side, to check records in below sequence:
Indoor or current CH MAX temperature Indoor or current CH MIN temperature Indoor or current CH MAX humidity
Indoor or current CH MIN humidity outdoor MAX temperature outdoor MIN temperature outdoor MAX
humidity outdoor MIN humidity MAX Feels like temperature MIN Feels like temperature MAX heat index
temperature MIN wind chill temperature MAX dew point temperature MIN dew point temperature MAX
average wind speed MAX gust wind MAX Beaufort MAX relative baro pressure MIN relative baro pressure
MAX absolute baro pressure MIN absolute baro pressure MAX rain rate MAX UV index, MAX light
intensity. Then press [ MEM ] key for back to normal mode.
You can also, press another key to exit memory mode.
Press and hold [ MEM ] key for 2 seconds to reset the current displayed record.
CALIBRATION
The console is able to calibrate the weather readings:
1. In normal mode, press and hold [ CAL ] key for 2 seconds to enter the
calibration mode as shown on the right.
2. Press [ CH / SET ] key to select different parameter as sequence: Indoor
temperature Indoor humidity CH temperature CH humidity
outdoor temperature outdoor humidity wind speed wind direction
absolute baro pressure rain gain UV gain light intensity gain.
3. While the reading is blinking, press [ WIND / + ] or [ - ] key to adjust the offset
value.
4. When finished, press [ CH / SET ] to proceed with next calibration by
repeating process 2 - 3 above.
5. To return normal mode, press [ CAL ] key once.
