55
USER’S MANUAL
5 SYSTEM EXPANSION
5.1 GENERAL:
You can register up to 4 cameras on the DVM-350 parent unit. Via the menu of the
parent unit you can select the desired camera or you can watch the images of all
registered cameras in order (scan function).
Expansion cameras are available through the service department of Alecto via the
phone number 073 6411 355 (NL) , 03 238 5666 (B), 0180 503 0085 (D) or via
www.alecto.nl
Camera: +DVM-340.100
Power adapter: +DVM-340.042
5.2 REGISTERING ADDITIONAL CAMERAS:
1. Connect the power adapter to the new baby unit, plug the adapter into a 230V
wall socket and switch on the camera.
2. Press and hold the parent unit button until after 4 seconds the image ‘ ‘
appears, followed by the camera number.
3. Use the parent unit buttons / to select a free ‘camera connection’.
A ‘ ‘ after a camera number shows a camera is already registered at this
number. In this case, if you register a new camera at this number, then the
old camera will be disconnected; it is therefore advisable to use a camera
without ‘ ‘
4. Shortly press the button , the light
will start flashing quickly.
5. Within 10 seconds, shortly press the button PAIR at the rear of the new came-
ra. The indicator light at the front of the camera will start flashing quickly.
6. After several seconds the parent unit will have detected the new camera and
the images of this camera will be shown on the display of the parent unit.
6 TIPS AND WARNINGS
6.1 GENERAL:
• Thoroughly read the user’s manual and follow all indications.
• Never place the baby unit or parent unit in wet or humid room or environment.
• Ensure adequate heat dissipation; never cover the parent unit, the baby unit
and/or the power adapter(s) and never place them directly next to a heat
source.
• Only use the supplied adapter(s); connecting a different type of adapter will
damage the electronics.
• Make sure the adapter cables are free of any damage and ensure nobody can
trip or fall because of these cables.
• Never dismantle the parent unit, the baby unit and/or the power adapter(s);
only qualified personnel is authorized to do so.
6.2 INSTALLATION:
• Only connect or disconnect the power adapter to/from the baby unit or parent
unit when the power adapter is removed from the wall socket.
• Never install the DVM-350 during thunder storms.
• Never touch any non-isolated adapter cables, unless the adapters are remo-
ved from the wall socket.
6.3 RECEPTION INDICATOR / OUT-OF-RANGE NOTIFICATION:
• In the upper left corner of the parent unit you can check the signal strength
received from the baby unit:
: very good reception
: good reception
: bad reception
• In all cases, the images and sound are displayed with the same quality.
• As soon as the parent unit loses the signal from the baby unit (out of range or
the baby unit is switched off), ‘ ’ (no reception)) and ‘Out of Range’ will appear
on the display. The unit will also emit two beep tones every 10 seconds.
• As soon as the parent unit is receiving the signal from the baby unit again, the
display will illuminate.
6.4 DELAY IN IMAGES AND SOUND:
• The baby unit transmits the images and sound to the parent unit in digital
blocks. The parent unit converts these signals back to a recognizable image
and a comprehensible sound. Therefore, there is a small delay between the
moment of movement and making sounds and the display and sounds of the
parent unit.
• Besides that, the sounds and images on the parent unit are not exactly simul-
taneous.
DVM-350-manual-NL-FR-D-GB-v1.0.indd 55
22-3-2016 15:01:55
