Laser function
Application
Blade selection two blades are available for this saw. each is for cutting different materials. select the
correct blade for your applications.
24 teeth TCT saw blade a is for wood cutting
60 teeth HSS saw blade b is for soft metal cutting
Installing Parallel Guide
●
Cleaning
●
●
●
●
Cleaning / Maintenance
Note: Laser light can cause severe eye damage. Never look directly
into the laser beam. Do not point the laser beam at other people or
animals, either directly or through reflective surfaces.
The laser feature on your saw is powered by two LR44 1.5V button
batteries (installed).
The Laser feature clearly shows you an extended cut-line, even over
debris on the work piece.
●
Turn it on with the laser light ON/Off switch right before cutting.
●
Turn it off immediately after use to conserve battery and laser life.
a
b
NOTE: The parallel guide enables exact cuts along a
workpiece edge and cutting strips of the same dimen-
sion.
Release the lock screw for guide fence on the base
plate and set the guide fence in the guide fence slot.
Set a desired width and retighten the lock screw for the
guide fence.
Always wear protective gloves when handling the saw blade 1 be done regularly. This will
ensure a long and reliable service life.
Remove the battery pack from the device before carrying out any work or transporting it. If the
device is switched on accidentally, there is a danger of injury.
Do not spray the appliance with water and do not immerse it in water. Electric shock hazard!
Keep clean the ventilation slots, motor housing and handles of the appliance.
Use a damp cloth or a brush. Do not use cleaning agents or solvents. You may otherwise irrepara-
bly damage the appliance.
Clean the saw blade holder 2 with a brush or by blowing out with compressed air.To do this,
remove the saw blade 17 from the device.
- 14 -
