■
The overload protection has not been triggered (see section "Overload
protection with restart lockout").
ON switch
The ON switch
10
switches the device on if the following conditions are fulfilled:
■
The standby LED
13
is lit red.
■
The function selection switch
9
is set to forward or reverse.
OFF switch
The OFF switch
11
switches the device off from forward mode.
Function selection switch
Use the function selection switch
9
to set the operating mode.
Forward
Forward is the normal operating mode. The material is pulled in
and shredded. When switched to this operating mode, the ON
switch
10
is fixed (continuous operation).
Reverse
Reverse is used to clear jammed material out of the device.
When switched to this operating mode, the ON switch
10
is not
fixed (no continuous operation).
Overload protection with restart lockout
The device is equipped with overload protection. If the motor is overloaded (e.g.,
branches that are too thick or wood that is too hard is/are inserted into the hopper),
the overload protection is activated.
- When the overload protection is activated, the standby LED
13
goes off.
- The device is automatically switched off and cannot be switched on again.
When the overload protection has been activated, you must reset the overload
protection (see section "Resetting the overload protection").
Resetting overload protection
After a switch-off due to overload, the device does not automatically switch on
again.
1. Wait one to two minutes.
2. Press the overload protection switch
12
.
The standby LED
13
is lit red when all other conditions are fulfilled (see section
"Operating panel").
The device is ready for operation.
Operation
17
