1. Undo the two quick-release levers
12
on the handle mount.
2. Set the handle to the desired height.
3. Check whether the serrations of the locking washer engage correctly in the
handle mount
11
.
4. Flick the quick-release levers
3
.
Adjusting the cutting height
You can set the cutting height between approximately 20 and 70 mm. The cutting
height lever
8
can be engaged in 7 positions.
1. Hold the device by the carry handle
7
.
2. Pull the cutting height lever
8
out of its arrester.
3. Slide the cutting height lever
8
to the desired level.
The device lifts or lowers.
4. Engage the cutting height lever
8
properly again.
Preparing for operation
Only use an extension cable if the included cable is insufficient for mowing the entire
lawn. Avoid using more than one extension cable.
1. Check the device, the collecting bag and the blade before connecting the power
supply.
2. Set the desired cutting height before connecting the power supply.
3. Check the handle position and correct it if necessary to work comfortably.
4. Lay out the power cable all along the perimeter of your lawn.
5. Secure the power cable on the pull relief
2
(see Fig. H ).
6. Plug the power cable plug into a properly installed socket.
Turning the motor on and off
Caution! Blade keeps moving
The motor is activated by means of a safety switch. When you let go of the safety bar,
the motor stops. Only turn on the motor on the grass.
1. Place the device on the grass.
2. Press and hold the button of the safety switch
16
.
3. Pull the safety bar
17
towards the handle.
The motor starts.
4. Let go of the safety switch button and keep the safety bar pressed to the handle
as long as you operate the motor.
Letting go of the safety bar stops the motor. The blade keeps running. Wait until the
blade has stopped before handling the device.
Operation
14
