24v Lithium-ion Cordless Drill with Hammer Action
AFTER SALES SUPPORT
e-mail: [email protected]
1800 909 909
MODEL: №. 2024001 • 02/2017 • 55945
(toll free)
AFTER SALES SUPPORT
(toll free)
e-mail: [email protected]
1800 909 909
24v Lithium-ion Cordless Drill with Hammer Action
MODEL: №.2024001 • 02/2017 • 55945
18
19
When fitting the drill bit, ensure to use a masonry drill bit suitably
designed for the application.
Rotate the function selection collar (3) so the symbol of the hammer
function (13) aligns with the triangular indicator on the top of the drill
housing (Fig K).
Inserting and removing bits
This drill/driver has a keyless chuck, which
means that a chuck key is not needed to secure
a bit in the drill/driver.
1. Open the chuck (1) by unscrewing it in an
anti-clockwise direction, holding the drill/driver
as shown (Fig L).
Do this sufficiently enough to allow the drill/
driver bit to enter the jaws of the chuck.
2. Ensure the drill/driver bit is fully inserted, so that the chuck jaws grip the
straight section of the bit.
Rotate the chuck clock-wise until the jaws tighten on the drill/driver bit.
The collar of the chuck needs to be tightened firmly to ensure the drill/
driver bit is held securely.
To remove the drill/driver bit, rotate sharply the chuck in an anti-
clockwise direction, sufficiently enough to allow the drill/driver bit to be
removed.
NOTE: This device is fitted with spindle lock and the chuck is a one
handed operation.
When using the drill/driver for screwdriving
1. Rotate the function selection collar (3) so to align the screw symbol with
the triangular indicator on the top of the drill housing (Fig I). Function
setting is screw function (14).
2. To adjust the torque setting, rotate the torque
setting collar (2). The higher the number, the
higher the output torque. Align the required
torque setting number with the triangular
indicator on the top of the drill (Fig I). Torque
setting is 11.
Controlling the torque allows better control
when applying screws in the screw function (14)
and assists in the prevention of over tightening
if the torque is correctly set.
For setting the torque position, always start off with a low torque setting
and build up to the required higher torque setting after testing on
a test piece first.
When using the drill/driver for drilling
1. When using the drilling function the torque
control has no effect to the output of the drill.
The drill function (15) is used to drill holes in
metal, non ferrous material, wood, plastic and
similar materials.
Rotate the function selection collar (3) so the
symbol of the drill bit aligns with the triangular
indicator on the top of the drill housing (Fig J).
When using the drill/driver for
hammer drilling
1. When using the hammer drilling function (13),
the torque control has no effect to the output of
the drill. The hammer drill function (13) is used to
drill holes in non fired, and non aggregate, but
cement based material or similar materials. The
action of the hammer is for drilling and not for
chiseling.
Using the Drill / Driver
in different modes
Inserting//Removing bits
K.
J.
L.
OPEN
CLOSE
I.