Alderon Industries™ - Leading Edge Control Products | 13
VertiMAC™ Pump Switch - USER GUIDE
General Operation
The VertiMAC™ is a float operated pump switch, typically used in sump pump applications or situations where a regular pump switch
cannot operate due to limited space. The VertiMAC™ pump switch is mounted in a vertical position to a pipe and is activated by
the float upon a rising water level. As the water level rises, the float pushes the actuator rod upward which activates the mechanism
inside the pump switch housing and turns the pump on. When the water level recedes, the float lowers the actuator rod downward
deactivating the mechanism inside the pump switch housing and turns the pump off. To adjust the pump differential, slide the rubber
grommet up or down the actuator rod for the desired pumping range. The applications are not limited to what is listed in this user
guide. Follow all individual instructions for sensors and accessories used with the VertiMAC™ pump switch.
The following applications can be found in this user guide: Sump Pump, Sump Pump with VertiMAC™ Sump Advisor™ System,
Sump Pump with Battery Backup, and Limited Space Dewatering.
Sump Pump
The diagram below is a typical setup for a sump pump application. The VertiMAC™ pump switch is mounted to the discharge
pipe and powered by a standard wall outlet using the piggyback plug power cable. The pump power cable is then plugged into
the female end of the VertiMAC™ piggyback plug. The float is used to operate the pump switch, turning the pump on and off
based on the pump differential for the desired pumping range.
5:05
PM
71%
REGENERATION
MENU
ENTER
House to Yard
VertiMAC™
Pump Switch
