If you select the function, please press “SW2”.
1.
Buzzer
You can turn the buzzer sound on or off by using ‘On’ or ‘Off’.
2.
Low Pass Level
The default number can be set from 0.000 to 0.040%BAC.
3.
Hi Danger Level
Being above the level entails you are over the legal limit permitted, and that you
must not drive.
The default number can be set from 0.050 to 0.100%BAC.
Go to “To enter the set up mode” again if you finish setting the function and then select
EXIT
.
Maintenance
The software product is easy to maintain, and its operating environment can be changed
without any special skills. It automatically checks and adjusts the accuracy rate of
measurement.
1.
If you want to check the total amount of tests, press SW1 and the display window will
show the test.
Press SW1 during 2 seconds and the count will be reset to 0, automatically returning
to normal operation mode.
Wait a few seconds after testing.
2.
When you adjust the number of coins for each test, press SW2 during 2 seconds.
The display window will show “set the coin number”, then press SW2 again. It will
allow from 0 to 10 coins per test.
If number 2 is entered, that means two coins are required. The default number was
set to 1.
Replacing sensors
SW1. Total Count
SW2. Set the coin number
SW3. Test
